Natitf Config On Ewon. Control software eCatcher Ewon HMI / configuration / access control I cannot find the security settings that was mentioned under networking in S7-300/400 ethernet configuration set access via Router and Subnet mask to EWON ip address
Ewon Cosy 131 WiFi Won't Connect Stuck on Wizard eWON Cosy from forum.hms-networks.com
In this case, the parameter "Nat and TF" must be set on "NAT on WAN" (NatItf : 2) Looking at the NAT document that you attached in this feed
parameters in the eWON A: WANPermCnx:1 FwrdToWAN:1 NatItf:2 - Note - With the example we gave, you would need to change these parameters in eWON A: EthIP:172.31.254.1 EthMask:255.255.255.252 In our example, the Ethernet device on the Ewon LAN side with IP address 192.168..115 will become reachable on the Ewon WAN side using IP address 10..101.11 NatItf = 2 (NAT and TF on WAN) VPNRedirect = 0 (Allow traffic outside the VPN tunnel) FwrdToWAN = 1 (Forward LAN traffic to WAN)
eCatcher > VPN tunnel error> STATE 1645107440,GET_CONFIG Ewon. in S7-300/400 ethernet configuration set access via Router and Subnet mask to EWON ip address NatItf:3 • To set the "Wan Protection" level to "Discard all traffic excepted VPN and initiated traffic": WANItfProt:1 • To disable the IP forwarding to the WAN port: FwrdToWAN:0 You can also apply these settings using a put FTP to the eWON root
Ewon Cosy 131 Manual. In our example, the Ethernet device on the Ewon LAN side with IP address 192.168..115 will become reachable on the Ewon WAN side using IP address 10..101.11 I am on the lastest firmware 13.3 and using eBuddy to.